4. Troubleshooting► Error CodeH2–6706► Error messageFinisher Failure: #H2-6706. Check finisher► SymptomTransport motor doesn’t work.► Troubleshooting method1) Open finisher jam cover to check if there is a paper jam. If there is paper, remove paper manually. Then closedoor to do finisher initialization.2) If transport motor is still not running and the error does not disappear, follow the instructions below:a) Does finisher transport motor work well?i) Make sure finisher transport motor cable is connected well to the transport motor connector.ii) Make sure finisher transport motor cable is connected well to the main board connector.iii) Replace the finisher transport motor(JC81–09677A).(Refer to 3.3.34.1 Finisher Main Motor)iv) Replace the finisher main board(JC81–09692A).(Refer to 3.3.34.2. Finisher Board)b) Does finisher input sensor work well?i) Make sure finisher input sensor cable is connected well to the sensor connector.ii) Make sure finisher input sensor cable is connected well to the main board connector.iii) Replace the finisher input sensor(JC81–09686A).(Refer to 3.3.34.1 Finisher Main Motor)iv) Replace the finisher main board(JC81–9692A).(Refer to 3.3.34.2. Finisher Board)c) Does finisher motor gear set work well?i) Make sure gear set can rotate smoothly.ii) Make sure each gear is not broken.iii) Replace the gear set(JC81-09592A / J81-09593A / JC81-09595A / JC81-09596A).d) Check if any debris is present. Please make sure to remove any debris.Copyright© 1995-2013 SAMSUNG. All rights reserved. 4-132
