Samsung DW7933LRASR/AA Installation Manual

Also see for DMT350 Series: Installation guide User manual Installation requirements Installation guide Service manual

Contents

8_ installing the dishwasherNew installationIf the dishwasher is a new installation, most of the installation work must be done before thedishwasher is moved into place.ReplacementIf the dishwasher is replacing an old dishwasher, you must check the exising dishwasher connectionsfor compatibility with the new dishwasher. Repace the existing connections as necessary.STEP 2 SELECT THE BEST LOCATION FOR THE DISHWASHERThe following criteria are important to ensure the best location for the dishwasher:- The location must have a solid floor that is able to support the weight of the dishwasher.- The location must be near a sink with easy access to the water supply, drain, and electricaloutlet.For the drain to operate properly, the dishwasher should be installed within 9.8 ft (3 m) ofthe sink.- The location must let you load your dishes into the dishwasher easily.- The location must have sufficient space for the dishwasher door to open easily and provideenough space between the dishwasher and the cabinet sides (at least 0.1 in (2 mm)).If the dishwasher is installed in a corner, ensure that the side of the dishwasher is more than2 in. (50 mm) from the wall or cabinet to its right or left.- The wall at the back must be free of obstructions.If this is a new installation, follow these steps:1. Using a 2 1 /2 inch hole saw, cut a hole into the side of the cabinet that holds the sink asshown in Figure 1 below.2. If the base inside the sink cabinet is raised above the kitchen floor and is higher than theconnections on the dishwasher, make a hole in the base inside the cabinet and in the cabinetside as shown in Figure 1-2.Depending on where your electrical outlet is, you may need to cut a hole in the oppositecabinet side.

The hole for the water supply line, drain hose andpower cables.installing the dishwasherinstallation_DD68-00046A-05_EN.indd Sec3:8installation_DD68-00046A-05_EN.indd Sec3:8 2011-12-28 4:27:242011-12-28 4:27:24