Samsung ITP-5112L User Manual

Also see for OfficeServ ITP-5112L: User guide User instruction User guide User instructions User guide

Contents

Samsung ITP-5112L User Manual Manual pdf 17 page image

ITP-5112L SETUPINITIALIZING THE ITP-5112LInitially the ITP-5112L IP keyset will need to be setup to operate within the usersnetwork.The Setup Menu is also used to make changes to the keyset, in the eventthat the system information should change. The option chosen via scroll buttonwill be highlighted.The station numbers will be automatically set by the OfficeServ 100, theOfficeServ 500, or the OfficeServ 7000 Series systems once the necessary infor-mation has been entered into the IP keyset. Enter ID and password of the server,as described below to register the phone.See your system administrator for specific Network and Server addresses. Theaddresses necessary to set up the ITP-5112L are:• IP Address of Station• Network Gateway Address• IP Address of System’s MCP• User ID• PasswordIP SETUP MENUTo get to the SETUP MODE unplug the power cord from the ITP. Press and holdthe MENU button while you plug power backinto the phone. Release the MENU buttonwhen you see the SETUP SCREEN. If you havea PoE (Power over Ethernet) connection, thesame procedure can be done by unpluggingand plugging the Ethernet cable into thephone while pressing and holding the MENUbutton.Once the CONFIGURATION MENU is dis-played, you can move to each menu in the SetUp by using the navigation buttons and [1]-[9] dial buttons of the ITP-5112L IPphone.• The UP and DOWN directions buttons in the navigation button assembly areused to move the highlighted bar up or down to the desired option.• The LEFT and RIGHT buttons in the navigation button assembly are used tomove the highlighted bar left or right, to the desired option, move to a submenu and if a menu is at the last line, that menu option will be executed.Configuration*1.System Easy Wizard2.System Information3.Network Setup4.Load & Upgrade Setup5.System Server Setup6.Factory Reset7.Reboot10