Samsung MagicLAN SWL-2100N User Manual

Contents

22i.e. AP or Client Stations, is good, adequate or poor.Link Quality: This is the measure of the radio link. You can also visualize the connectionstatus by seeing the following three different colors of Link Quality.• Green Color: The connection status is good. And the clients or AP should be able tocommunicate without disturbance.• Yellow Color: The connection status is adequate. In other words, you mayexperience some problems while communicating.• Red Color: The connection status is poor. You may not communicate with the otherclients or AP.Signal Level: This is the measure of the signal level. The measured signal level gives theoverall Link Quality and Connection Status.Noise Level: This is the measure of the noise level.You can change the configuration by clicking on the Configuration Change. When you clickon the Configuration Change, you see the screen given below.Configuration Change screen allows you to set the parameters as explained below.Net Mode: You can set the Network Mode to Infrastructure or Ad-hoc.SSID: The SSID can be changed to any value. But that should be the same that of AP. In caseof Ad-hoc Mode, the SSID should be same for all clients.TX Rate: The transmission rate at which the data packets are transmitted by the client or AP.You can set this to Auto select 1 or 2Mbps, Fixed 1 Mbps, Fixed 2 Mbps, Fixed 5.5 Mbps,Fixed 11 Mbps or Full Auto (1 to 11 Mbps).Important: You must know the TX Rate that your AP can support. Failure to which may