Wireless network setup1642. Using a Network-Connected Machine13 The Wireless Network Setting Complete window appears. Click Next.14 When the wireless network settings are completed, disconnect the USBcable between the computer and machine. Click Next.15 Follow the instructions in the installation window.Access point without a USB cableItems to prepare• WiFi-enabled Mac running Mac OS 10.7 or higher and an access point(router)• Software CD that was provided with your machine• A machine installed with a wireless network interface1 Make sure that the machine is connected to your computer andpowered on.2 Insert the supplied software CD into your CD-ROM drive.3 Select the CD-ROM volume that appears on Finder.4 Double-click Install Software icon.5 Read the license agreement and check installation agreement button.6 Click Next.7 Select Wireless on the Printer Connection Type screen.8 Click Next.9 If the installer asks you to allow access to the keychain, click Allow.10 If the Select a wireless printer window appears, select the printernamed DIRECT-xxx.If the Press WPS button on your printer screen appears, press the(WPS) button from the control panel within 2 minutes.11 When the wireless network set up is complete, follow the instructions inthe installation window.15Using a network cableSee your network administrator, or the person that set up your wirelessnetwork, for information about your network configuration.Your machine is a network compatible machine. To enable your machine to work withyour network, you will need to perform some configuration procedures.
