ŝ79ŞFlash Synchro.Flash Pop-upDirect MFSpot AE pointSizeQualityEffectCenterFocus Areaƈ You can select a spot AE point where the brightness is calculated.ƃ How to set the spot AE point in the Program mode1. Select the spot metering mode (p.43).2. Press the Menu button and select the [P] menu tab.3. Press the Right button and select the [Spot AE point]menu by pressing the Up/ Down button.4. Press the Right button and select a desired menuby pressing the Up/ Down button.- [Center] : The brightness is calculated based onthe + marked area placed on the centreof the Rear LCD. Select this menu whenthe subject is in the backlight shootingcondition or in the shadow.- [Focus Area] : The brightness is calculated based on where the auto focus frame is placed.If there is a gap of brightness between the subject and centre part of the LCD,select this menu. Refer to page 46 for more information about how to set theSpot AE point. It is the same as those for AF-A setting up.5. Press the OK button to set the setting.Spot AE (Auto Exposure) point
