setting up _901 SETTING UPFLOORINGFor proper installation, you must place thisrefrigerator on a level, hard surface that is thesame height as the rest of the floor. This surfaceshould be strong enough to support a fully loadedrefrigerator, or approximately 335lbs (152kg).To protect the finish of the flooring, cut a largesection of the cardboard carton and place it underthe refrigerator where you are working. Whenmoving the refrigerator, you need to pull and pushit straight forwards or back. Do not wiggle it fromside to side.REQUIRED TOOLSRequired Tools (Not provided)You need the following tools to complete theinstallation of your refrigerator:Philipsscrewdriver(+)Flat-blade screwdriver(-)Socket wrench(10mm)Allen wrench(3/16”) (5mm)REMOVING THE REFRIGERATORDOORSFor some installations you need to remove thefridge and freezer drawers so you can move therefrigerator to its final location. Do not removethe doors/drawer if you don’t need to. If you donot need to remove the refrigerator doors, go toAdjusting the Level on page 12. If you need toremove the doors. continue below.Before removing the door/drawer, make sure youread the following items:Disconnect power to the refrigeratorbefore removing the door or drawer.• Be careful not to drop, damage orscratch the door/drawer while removingthem.• Use care when you remove the doors/drawer.The doors are heavy and you could injureyourself.• Reattach the doors/drawer properly to avoid:- Moisture from air leakage.- Uneven door alignment.- Wasting energy due to improper door seal.HOW TO ASSEMBLE THE HANDLEOrient each handle so that the end with the stickerattached is at the top and the holes with thetightening screws are facing each other.Then, follow the directions below to install eachhandle.By using Phillips screwdriver, fix the screw(optional) and then put the handle on the fixer bysliding them down firmly.WARNINGDA68-02601A-16.indb 9 2018. 10. 8. 오후 4:31