setting up _1101 sEtting uPsetting up your side-by-siderefrigeratorsEtting uP thE rEfrigErator DoorsIf your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.Removing the Front Leg CoverFirst, open both the freezer and refrigerator doors, and then take off the front leg cover byturning the three screws counter-clockwise.Separating the Water Supply Line from the Refrigerator1. Remove two water lines(gray one is for ice and the other one is for water)by pressing thecoupler 1 and pulling the water line 2 away.:Reattaching the Water Supply Line1. Water line must be fully inserted to the marked line to prevent water leakage and waterdripping of water dispenser.2. Insert the 2 clips in the install pack and check that each clip holds the line firmly.Do not cut the water line. Gently separate it from the coupler.line lineCoupler CouplerCouplerclip A(6.35mm)clip A(6.35mm)12Be careful that thewater tube match samecolor.CouplerDA99-01745T(EN)-GGH-0.4.indd 11 2010.12.16 10:20:15 AM