16_ setting upChECKing thE watEr DisPEnsEr LinEA water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promotebetter health, the Samsung water filter removes unwanted particles from your water. However, it does notsterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normalconditions, a 170 cc paper cup can be filled in 10 seconds.If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a boosterpump to compensate for the low pressure.Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the waterdispenser lever until the water runs from the water outlet.Water Line installation Kits are included with unit. You can find it in freezer(or fridge) drawer.Parts for water line InstallationConnecting to the water supply line1. first, shut off the main water supply line.2. locate the nearest cold, drinking water line.3. follow the Water line installation instructionsin the installation kit.4. After connecting the water supply to the water filter, turn your main water supplyback on and dispense about 3l to clear and prime the water filter.Close MainWater pipeClose MainWater pipe no gap1 Water line fixerand screws 2 Pipe connector 3 Water line 5 Water filterCAUTIONThe water line must be connectedto the cold water pipe.If it is connected to the hotwater pipe, it may cause thepurifier to malfunction.4 ClipDA99-01745T(EN)-GGH-0.4.indd 16 2010.12.16 10:20:26 AM