Samsung RSH1UTPE User Manual

Contents

18_ setting up3. After adjusting the doors, turn the nut 1 clockwise until it reaches the lower end of thebolt, then tighten the bolt again with the wrench 3 to fix the nut in place 1 .If you do not secure the nut firmly, the bolt may release.Close MainWater pipeClose MainWater pipeNo gap321WrenchBoltNutCHECKing tHE watEr DisPEnsEr LinE (oPtionaL)A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote betterhealth, the Samsung water filter removes unwanted particles from your water. However, it does not sterilizeor destroy microorganisms. You will need to purchase a water purifying system to do that. In order for theicemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 ccpaper cup can be filled in 10 seconds. If the refrigerator is installed in an area with low water pressure (below138 Kpa), you can install a booster pump to compensate for the low pressure. Make sure the water storagetank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs fromthe water outlet.Water Line installation Kits are included with unit. You can find it in freezer drawer.instaLLing tHE watEr DisPEnsEr LinEFor Interior modelParts for water line Installation1 Water line fixerand screws 2 pipe connector 3 Water line 4 Water FilterConnecting to the water supply line1. first, shut off the main water supply line.2. locate the nearest cold, drinking water line.3. follow the Water line Installation Instructions in theinstallation kit.CAUTIONThe water line must be connectedto the cold water pipe. If it is connectedto the hot water pipe, it may cause thepurifier to malfunction.4. After connecting the water supply to the water filter, turn your main water supply back on anddispense about 1l to clear and prime the water filter.