English - 166. Attach the front of the Top Cover, and thenpress down on its back until it lies fl at. Re-attach the screws.• Assemble the Fridge and Freezer doorsin the reverse order of disassembly.• If the Wire Connectors are cross-assembled,the display will not work properly.• Clips are located inside the cap on the top.• To prevent water leaks, if the refrigerator usesred clips, make sure the red clips are properlyconnected to the Coupler after you insert theWater Tube [E] into the center of the Coupler.Center of theCenter of theIndicator LineIndicator Lineclip Aclip A(6.35 mm)(6.35 mm)EE• Keep the clips out of the reach ofchildren and make sure that children donot play with them or put them into theirmouths.CAUTIONCAUTIONLEVELING THE REFRIGERATORAND ADJUSTING THE DOORHEIGHT AND THE GAP BETWEENTHE DOORSHOW TO LEVEL THE REFRIGERATORIf the Refrigerator is not level, it can cause a heightdifference between the doors.• Insert a Flat-Head (-) Screwdriver into the slot inthe Leveling Leg Control Lever and adjust thelevel by turning the Control Lever clockwise orcounter-clockwise. When you rotate the Leverclockwise, you raise the refrigerator. When yourotate the Lever counter-clockwise, you lowerthe refrigerator.fl at-bladefl at-bladescrewdriver(-)screwdriver(-)Control LeverControl Lever• If the Refrigerator is not level back andfront, put a solid panel (such as a plasticpanel, a plastic ruler, etc.) on the fl oorwhere the rear legs will rest, and then fi xit in place with plastic tape. When youpush in the Refrigerator, make sure therear legs rest on the panel.• If you have a wooden fl oor or similar soft fl oor,take care not to damage the floor when pushingthe Refrigerator into place.DA68-03013A-03.indb 16DA68-03013A-03.indb 16 2014. 2. 25. 4:042014. 2. 25. 4:04