| 
5-36 Chapter 5CLI (Command Line Interface)[12] MMC Port Block/UnBlockFunction You can set Block/UnBlock on each port of the system. ‘Block’ indicates‘disabled to use’ and ‘UnBlock’ indicates ‘enabled to use’.Procedure 1. In the screen, type ‘12’, and press [Enter].2. Type ‘1’ to block or ‘2’ to unblock, and press [Enter].Select Block or UnBlock (1: Block, 2: UnBlock) ->3. Input the slot number for the port specified to be unblocked, and press [Enter].Blocking Slot Number: (0: VoIP, 1: SLI, 2: LOOP)4. Input the port number, and press [Enter].Blocking Port No. of VoIP Slot (Range: 0 ~ 0x1F) [ . :Exit ] ->5. You can continue with other ports by typing in the corresponding port numberand pressing [Enter].Blocking Port No. of VoIP Slot (Range: 0 ~ 0x1F) [ . :Exit ] ->6. To exit, type ‘.’, and press [Enter]. You will return to the Menu> screen. |
