Samsung VP-D10 Service Manual

Also see for VP-D10: Owner's instruction book Owner's instruction book Owner's instruction book Owner's instruction book Owner's instruction book

Contents

Samsung Electronics 8-18. Schematic DiagramsPage8-28-38-48-58-68-78-88-98-108-118-128-138-148-158-168-178-188-198-208-1 EVF - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-2 Audio - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-3 Camera - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-4 Camera A/F - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-5 CCD - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-6 Channel - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-7 Codec - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-8 Rear - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-9 DC DC - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-10 Function - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-11 IEEE 1394 - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-12 Main-Micom - - - - - - - - - - - - - - - - - - - - - - - - - - -8-13 Prml - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-14 Servo - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-15 Timer-Micom - - - - - - - - - - - - - - - - - - - - - - - - - - -8-16 Video - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-17 LCD - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-18 Pre Amp - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-19 USB - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -For schematic Diagram- Resistors are in ohms, 1/8W unless otherwise noted.- Circled numbers refer to waveforms.NoteSpecial note :Most semiconductor devices are electrostatically sensitive and therefore require the special handling techniquesdescribed under the “electrostatically sensitive (ES) devices” section of this service manual.Note :Do not use the part number shown on this drawing for ordering. The correct part number is shown in the partslist (may be slightly different or amended since this drawing was prepared).Important safety notices :Components identified with the mark ! have the special characteristics for safety. When replacing any of thesecomponents. Use only the same type.