EnglishForeword 10Names and functions of parts (rear panel)Basic connectionsUSB LAN TERMINATERS-485OFF ONA RS-485 BALARM INAC INSENSORALARM OUTCCLOCK INCLOCK OUTALARM OUTALARM RESETALARM FULLNON REC OUTWARNING OUTFULLSERIES OUTEXIT TIMER INSERIES INREMOTECONTROLC 1 2 3 4 5 6C 1 2 3 4 5 6CR1 R21INOUTALLRESETAUDIOMON2MIC ININ OUT2 3 4 5 6MAIN1 2 3 4 5ALLRESETMIC IN USB3 Video input terminal (Video IN)Connect SANYO protocol cameras (dome or zoom) or genericcameras to these terminals. (P70)Camera (sold separately)2 Video output terminal (Video OUT)Outputs the image input in the Video inputterminal.1 Clear button (ALL RESET)Press to reset the clocks connected to the digital videorecorder to their initial values.5 Microphone input terminal(MIC IN)External microphone can beconnected to this terminal.7 USB terminal (USB)This terminal connects to anoptional CD-R/RW drive.8 Power socket and cord tie(AC IN~)Securely connect the power cable supplied asan accessory to the power socket, and use thecord tie to attach it to thecable holder.Microphone(sold separately)4 Audio input/output terminals (AUDIO IN/OUT)These terminals are used in connection with an amplifier toinput external audio from a microphone, or to listen to theaudio using external speakers.The audio input terminal and the microphoneinput terminal cannot be used forsimultaneous audio input. If both areconnected, the microphone input terminalwill be enabled.AUDIOIN OUTAudio outputAmplifier(sold separately)Audioinput6 Monitor connection terminal (MONITOR OUT)• Main monitor terminal (MAIN):Connect to this terminal for normal surveillance.• Monitor 2 terminal (MON2):Connect to this terminal for convergence surveillance.Display is possible only in full-screen mode.If monitor 2 is not synchronized with the connectedcameras, vertical image instability may occur whenswitching the camera video.MONITOR OUTPOWERMODEAUTOMENU02010403 POWERMODEAUTOMENUMON2MAINVideo input terminal Video input terminalMonitor (sold separately)
