EnglishGeneral settingsHow to set 701 Connect the RS-485 terminal on the rear panel ofthe DVR with the system controller (Figure 1).2 Display the screen as explained in"Displaying the general settings screen", and thenturn the S-dial clockwise. (P62)The DATA SPEED "19200" indicator starts blinking.3 Turn the J-dial to select the desired DATA SPEED(example: 9600), and then turn the S-dial twiceclockwise.Selections: 2400/4800/9600/19200The "OFF" indicator of STATUS INFO starts blinking.4 Repeat the procedure for selecting the desiredsettings for each item.• STATUS INFOOFF: The status information will not be sent.ON: The status information will be sent.• ALARM INFOOFF: The alarm information will not be sent.ON: The alarm information will be sent.• ADDRESSThe address should be between 000~127.Refer to the system controller's instruction manual formore information about the control method.5 Press the EXIT/OSD button.F RS-485 settingsMENU(J) (S) SET>DATA SPEED : 19200STATUS INFO : OFFALARM INFO : OFFADDRESS : 0016.RS-485 SET3.GENERAL SETSTATUS INFO : OFFEXIT/OSDPOWERMODEAUTOMENURS485 BA6 1VIDEOCOMSWON1 2 3 4A BTELEMETRY12VSWON1 2 3 4 RS-485TERMINATEOFF ONRS-485TERMINATEOFF ONCARDCARDMENURESETEJECTCARDCARDMENURESETEJECTFigure 1 (Do not use telephone wires.)System controller(sold separately)Straight cable Cross cableTo otherA terminalsThe DVR supports straight and cross-type cables.• Straight type:A straight cable connects connector "A" to "A", and"B" to "B" of the RS-485 connectors.• Cross type:A cross cable connects connector "A" with "B", and"B" with "A" on the RS-485 connectors.Pin number Connector A Connector B1 Not used Not used2 Not used Not used3 A B4 B A5 Not used Not used6 Not used Not usedCamera (sold separately)Terminator switch settingsIf multiple devices are connected, terminator settings arenecessary at both ends. If the terminator settings are notcorrect, correct data will not be sent to the devices.• Set the terminator switch on both ends (first device and lastdevice) to "ON", and set it to "OFF" on all other devices.
