EnglishGeneral settings63 How to setThese settings are used to control the operating displayarea of the monitor, to display the date, time and otherinformation. Normally all indicators are displayed, butthey can be hidden, if needed."VIDEO LOSS" can be set to be displayed when a cameravideo is interrupted due to an unexpected problem, or alamp connected to the rear panel control terminals canbe turned on.1 Display the screen as explained in"Displaying the general settings screen", and thenturn the S-dial clockwise. (P62)The "ON" indicator on the DATE line starts blinking.2 Turn the J-dial, set the DATE to "OFF", and thenturn the S-dial clockwise.Repeat the same procedure for each item you want tohide from the display.b The operating display area after setting theitems "ON".3 Turn the J-dial, select "VIDEO LOSS", and turn theS-dial clockwise.The "ON" field starts blinking.Normally this is set to display. If necessary, turn theJ-dial and hide it by setting it to "OFF".4 Turn the S-dial clockwise.5 Press the EXIT/OSD button.☞ Cancelling the VIDEO LOSS detection• Connect a normal video signal.• If video signal connection is not necessary, then press thecamera selection button where the VIDEO LOSS wasdetected, and then press the same camera selectionbutton again for about 3 seconds.A Data display settings/VIDEO LOSS settingsMENU(J) (S) SET>DATE : ONTIME : ONQUALITY : ONAUDIO : ONALARM COUNT : ONALARM TYPE : ONTITLE : ONVIDEO LOSS : ON1.DISPLAY SET3.GENERAL SET01-01-06 00:00:00 REC REPEAT EN A ALARM 0000 SET>DATE : OFFTIME : OFFQUALITY : OFFAUDIO : OFFALARM COUNT : OFFALARM TYPE : OFFTITLE : OFFVIDEO LOSS : ON1357246021 273 46 501-01-06 00:00:00 REC REPEAT EN A ALARM 0000(J) (S) SET>DATE : ONTIME : ONQUALITY : ONAUDIO : ONALARM COUNT : ONALARM TYPE : ONTITLE : ONVIDEO LOSS : ONEXIT/OSD
