Sanyo PLC-WL2500 - 2500 Lumens Manual

Also see for PLC-WL2500: Command list Owner's manual Manual Owner's manual Brochure

Contents

Sanyo PLC-WL2500 - 2500 Lumens Manual Manual pdf 21 page image

PLC-WL2500 / WL2501 Expand Serial Command Functional Specifications20/728.4.11 CF_IMAGE CommandCommand “CF_IMAGE_%1”[CR]%1“DYNAMIC” ------ Dynamic (Fixed value to enable projection with a sharp, powerfulpicture tone)“STAND” ---------- Standard (Image adjust value is set to factory default)“REAL” ------------ Real (Fixed value to display graphic image with natural tone)“CINEMA” -------- Cinema (Fixed value to focus on tone reproduction for movie)“BLACKBOARD” – Blackboard (Fixed value to project image onto green-coloredblackboard)“COLORBOARD ” – Colorboard(Fixed value to project image onto colored board)“CUSTOM1” ----- Image1 (the value set and stored by a user)“CUSTOM2” ----- Image2 (the value set and stored by a user)“CUSTOM3” ----- Image3 (the value set and stored by a user)“CUSTOM4” ----- Image4 (the value set and stored by a user)DetailsSelect Image ModeParameter “CUSTOM1” to “CUSTOM4” is the same as “Image1” to “Image4”displayed when selecting Image on OSD menu.The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.12 CF_COLBOARD CommandCommand “CF_COLBOARD_%1”[CR]%1“RED” --------------Select Red“BLUE” ------------ Select Blue“YELLOW” ------- Select Yellow“GREEN” --------- Select GreenDetailsSelect Color of Colorboard mode.Image mode is automatically switched to Colorboard mode by receiving thiscommand.The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.13 CF_IMAGEADJ CommandCommand “CF_IMAGEADJ_%1”[CR]%1“RST” ------- Reset Image adjustment“STR1” ----- Store current Image adjustment to Image 1“STR2” ----- Store current Image adjustment to Image 2“STR3” ----- Store current Image adjustment to Image 3“STR4” ----- Store current Image adjustment to Image 4DetailsReset / store Image adjustment.Parameter “STR1” to “STR4” is the same as “Image1” to “Image4” displayed whenadjusting Image on OSD menu and selecting “Store”The value stored to “Image1-4” is saved and its setting is effective even after ALLis OFF.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]