Sanyo PLC-WL2500 - 2500 Lumens Manual

Also see for PLC-WL2500: Command list Owner's manual Manual Owner's manual Brochure

Contents

Sanyo PLC-WL2500 - 2500 Lumens Manual Manual pdf 23 page image

PLC-WL2500 / WL2501 Expand Serial Command Functional Specifications22/728.5.4 CF_H – POS CommandCommand “CF_H-POS_%1”[CR]%1“0000~nnnn” --- Directly select Horizontal Position setting value“nnnn” shows maximum value, it is current Total Dots value - Display Dots value“UP” -------------- Current Horizontal Position setting value + 1“DN” -------------- Current Horizontal Position setting value - 1DetailsSet Horizontal Position value of PC signal.The value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.5.5 CF_V – POS CommandCommand “CF_V-POS_%1”[CR]%1“0000~nnnn” --- Directly select Vertical Position setting value“nnnn” shows maximum value, it is current Total Line value - Display Line value“UP” -------------- Current Vertical Position setting value + 1“DN” -------------- Current Vertical Position setting value – 1DetailsSet Vertical Position value of PC signalThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “101”[CR] ---- When Input source is Video system8.5.6 CF_DDOTS CommandCommand “CF_DDOTS_%1”[CR]%1“0256”~”nnnn” --- Directly select Display Dots setting value“nnnn” shows maximum value, it is current Total Dots value - HorizontalPosition valueEven number is available and when odd number is set, it is rounded out.“UP” -------------- Current Display Dots setting value + 2“DN” -------------- Current Display Dots setting value – 2DetailsSet Display Dots value of PC signalThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]