Sanyo PLC-WL2503 - 2500 Lumens Manual

Also see for PLC-WL2500: Command list Owner's manual Manual Manual Owner's manual

Contents

Sanyo PLC-WL2503 - 2500 Lumens Manual Manual pdf 18 page image

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications17/728.4 Image Command8.4.1 CF_BRIGHT CommandCommand "CF_BRIGHT_%1”[CR]%1"000~063” --------------- Directly select Brightness setting value"UP” ----------------------- Current Brightness setting value + 1"DN” ----------------------- Current Brightness setting value – 1DetailsSet Brightness value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.4.2 CF_CONT CommandCommand “CF_CONT_ 1”[CR]%1“000~063” --------------- Directly select Contrast setting value“UP” ----------------------- Current Contrast setting value + 1“DN” ----------------------- Current Contrast setting value – 1DetailsSet Contrast value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable "Error Code”[CR]8.4.3 CF_COLOR CommandCommand “CF_COLOR_%1”[CR]%1“000~063” ---------------- Directly select Color setting value“UP” ------------------------ Current Color setting value + 1“DN” ------------------------ Current Color setting value - 1DetailsSet Color value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.4.4 CF_TINT CommandCommand “CF_TINT_%1”[CR]%1“000~063” --------------- Directly select Tint setting value“UP” ----------------------- Current Tint setting value + 1“DN” ----------------------- Current Tint setting value – 1DetailsSet Tint value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]