Sanyo PLC-WL2503 - 2500 Lumens Manual

Also see for PLC-WL2500: Command list Owner's manual Manual Manual Owner's manual

Contents

Sanyo PLC-WL2503 - 2500 Lumens Manual Manual pdf 19 page image

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications18/728.4.5 CF_SHARP CommandCommand “CF_SHARP_%1”[CR]%1“000~015” ---------------- Directly select Sharpness setting value“UP” ------------------------ Current Sharpness setting value + 1“DN” ------------------------ Current Sharpness setting value - 1DetailsSet Sharpness value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.4.6 CF_GAMMA CommandCommand “CF_GAMMA_%1”[CR]%1“000~015” ---------------- Directly set Gamma setting value“UP” ------------------------ Current Gamma setting value + 1“DN” ------------------------ Current Gamma setting value – 1DetailsSet Gamma value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.4.7 CF_WBAL - CommandCommand “CF_WBAL-%1_%2”[CR]%1“ ” --------------------- Red“ ” --------------------- Green“ ” --------------------- Blue%2“000~063” ----------- Directly select Color value specified by White Balance%1“UP” ------------------- Current Color value set by White Balance%1 + 1“DN” ------------------- Current Color value set by White Balance%1 - 1DetailsSet Color value set by White Balance%1 of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Standby status or ALL is OFF, the value returns to original setting.(The value is held in Suspend mode.)This command is available in normal Power ON status.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]