Sanyo PLC-WL2503 - 2500 Lumens Manual

Also see for PLC-WL2500: Command list Owner's manual Manual Manual Owner's manual

Contents

Sanyo PLC-WL2503 - 2500 Lumens Manual Manual pdf 36 page image

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications35/728.10.3 CF_AUTOSETUPPCADJ CommandCommand “CF_AUTOSETUPPCADJ_%1”[CR]%1 “ON” ------------------- Set Auto PC ADJ. function to ON“OFF” ------------------ Set Auto PC ADJ. function to OFFDetailsSet/Cancel Auto PC adj. functionThis command is available in normal Power ON status.Note) It is unable to set both PC ADJ. and Input search to OFF.If projector receives Auto PC ADJ. OFF command while Input search is OFF, itreturns error code “101”.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.10.4 CF_INPUTSEARCH CommandCommand “CF_INPUTSEARCH_%1”[CR]%1“OFF” ------------------------- Set Input search operation to OFF“ON1” ------------------------- Set Input search operation to On1“ON2” ------------------------- Set Input search operation to On2DetailsSet Input search operation mode.The status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Note) It is unable to set both PC ADJ. and Input search to OFF.If projector receives Input search OFF command while Auto PC ADJ. is OFF, itreturns error code “101”.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.10.5 CF_AUTOSETUPCommand “CF_AUTOSETUP_%1”[CR]%1 “START” ------------------- Execute Auto SetupDetailsExecute Auto SetupNote) CF commands does not execute while Auto setup is in process. If thecommand is sent during this, projector returns error code “302”Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.10.6 CF_BACKGND CommandCommand “CF_BACKGND_%1” [CR]%1“BLUE” -------------------- Select Blue Back“USER” ------------------- Select User“BLACK” ------------------ Select Black Back“UP” ---------- Switch forward (Blue Back→User→Black Back→Blue Back)“DN” --------- Switch backward (Blue Back→Black Back→User→Blue Back)DetailsSet Screen status for no signal.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.*When 1=”USER” is received, error code “101” is returned, in the case ofCapture non-practice.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]