Sanyo PLC-XD2200 Service Manual

Also see for PLC-XD2200: Owner's manual Easy setup Manual Manual Command list

Contents

-46-Electrical AdjustmentsGroup/Item Item Name Function Initial range Note9 DIMMER_CTRL_LEVEL10 Luminance Level 10 Data for Dimmer:Dim Level 10 at the less than theValue 70 0-25510 DIMMER_CTRL_LEVEL11 Luminance Level 11 Data for Dimmer:Dim Level 11 at the less than theValue 77 0 - 25511 DIMMER_CTRL_LEVEL12 Luminance Level 12 Data for Dimmer:Dim Level 12 at the less than theValue 84 0 - 25512 DIMMER_CTRL_LEVEL1 Luminance Level 1 Data for Dimmer:Dim Level 1 at the less than theValue 91 0 - 2551 DIMMER_CTRL_LEVEL14 Luminance Level 14 Data for Dimmer:Dim Level 14 at the less than theValue 98 0 - 25514 DIMMER_CTRL_LEVEL15 Luminance Level 15 Data for Dimmer:Dim Level 15 at the less than theValue 105 0 - 25515 DIMMER_AVERAGE_POINT Luminance Data Avarage Point forMimmer 4 0 - 1616 DIMMER_AVERAGE_DATA Luminance Data Avarage Value forDimmer - - * Read only17 DIMMER_LEVEL_AUTO Current Dimmer Leverl - - * Read only18 DIMMER_LEVEL_NORMAL Normal Dimmer Level 12/7 0 - 15 (PLC-XD2600/PLC-XD2200)19 DIMMER_LEVEL_ECO Eco Dimmer Level 1/1 0 - 15 (PLC-XD2600/PLC-XD2200)20 Lamp check enable 0 0: Lamp Failure Detection OFF(White 50% Back), 1 : ON (Blue100% Back)21 VOLTAGE_LEVEL Lamp Voltage - Unit: 8bit(Raw Data) * Read only22 DIMMER_LEVEL_HIGH Dimmer level High 15/12 0 - 15 (PLC-XD2600/PLC-XD2200)2 Past Calculation System - -24 New APL System - -25 Red Average Level - -26 Green Average Level - -27 Blue Average Level - -29 SAT - -29 Chroma Coefficient 160 0-2550 cSatMin 5 0-2551 cSatMax 20 0-2552 wCoeMin 400 0-1000 wCoeMax 1000 0-1000Group231 VBI Slice level0 Generic Initial Slicing Level PW190 register 0xE44 9 0-2551 Generic High Level Threshold PW190 register 0xE45 0 0-2552 Generic Low Level Threshold PW190 register 0xE46 0 0-255 Generic Minimum Low Level PW190 register 0xE47 0 0-2554 Generic Maximum High Level PW190 register 0xE48 255 0-255Group250 FAN control0 FAN1 MIN ADJUST (DAC) DAC Output for FanAdjust the tolerance of DAC and FanVolage.* Lamp mode is forced Eco8 0 - 2551 FAN1 MAX ADJUST (DAC) 2 0 - 2552 FAN2 MIN ADJUST (DAC) 8 0 - 255 FAN2 MAX ADJUST (DAC) 20 0 - 2554 FAN MIN ADJUST (DAC) 18 0-2555 FAN MAX ADJUST (DAC) 240 0-2556 Not used7 Not used8 Href 100 0 - 99999 Vref 00 0 - 999Group251Not usedGroup252 FAN option0 HI-LAND SWITCH 0: Normal, 1: Hi-Land, 2-4: Hi-Land1- 0 0 - 51 SAFETY SWITCH For test purpose 0 0 - 62 FAN MANUAL SWITCH 0: Auto, 1: Manual 0 0 - FAN1 MANUAL VOLTAGE Fan Voltage (unit : 0.1V)Effective only when Fan Manualswitch is 1100 0 - 2554 FAN2 MANUAL VOLTAGE 100 0 - 2555 FAN MANUAL VOLTAGE 100 0 - 255