Sanyo PLC-XF46E Owner's Manual

Also see for PLC-XF46E: Owner's manual Specifications Service manual

Contents

20BEFORE OPERATION16.4’(5 m)60°16.4’(5 m)60°To insure safe operation, please observe following precautions :● Use (2) AA or R06 type alkaline batteries.● Replace two batteries at same time.● Do not use a new battery with an used battery.● Avoid contact with water or liquid.● Do not expose Remote Control Unit to moisture, or heat.● Do not drop Remote Control Unit.● If a battery has leaked on Remote Control Unit, carefully wipe case clean and install new batteries.● Danger of explosion if battery is incorrectly replaced.● Dispose of used batteries according to batteries manufacturers instructions and local rules.Pull up lid andremove it.Remove batterycompartment lid.Slide batteries intocompartment.Replace compartment lid.Two AA size batteriesFor correct polarity (+ and–), be sure batteryterminals are in contactwith pins in compartment.REMOTE CONTROL BATTERIES INSTALLATION1 2 3Operating RangePoint Remote Control Unit towardprojector (Infrared Remote Receiver)whenever pressing any button.Maximum operating range for RemoteControl Unit is about 16.4’ (5m) and60° in front and rear of a projector.