Sanyo PLC-XF46E Owner's Manual

Also see for PLC-XF46E: Owner's manual Specifications Service manual

Contents

27COMPUTER INPUTThis projector automatically tunes to most different types of computers based on VGA, SVGA, XGA, SXGA, WXGA or UXGA(refer to “COMPATIBLE COMPUTER SPECIFICATIONS” on page 51-52). When selecting Computer, this projectorautomatically tunes to incoming signal and projects proper image without any special setting. (Some computers need settingmanually.)Note : Projector may display one of following messages.When projector cannot recognize connected signal as PCsystem provided in this projector, Auto PC Adjustmentfunction operates to adjust projector and message “Auto”is displayed on SYSTEM Menu icon. (Refer to P28.)When image is not provided properly, manual adjustmentis required. (Refer to P29 and 30.)There is no signal input from computer. Make sureconnection of computer and a projector is set correctly.(Refer to TROUBLESHOOTING on page 47.)Auto––––PC SYSTEM Menu iconDisplays system beingselected.PC SYSTEM MENUSELECT COMPUTER SYSTEM MANUALLYPC SYSTEM Menu iconDisplays system being selected.Systems on this dialog box canbe selected.Press MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT buttons to move a red frame pointer to PCSYSTEM Menu icon.Press POINT DOWN button to move a red arrow pointer tosystem that you want to set, and then press SELECT button.12PC SYSTEM MENUCustom Mode (1~5) set in PCADJUST Menu. (P29, 30)This projector automatically selects PC system among those providedin this projector and PC system can be also selected manually.AUTOMATIC MULTI-SCAN SYSTEMPress MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT button to move a red frame pointer toINPUT Menu icon.Move a pointer to "RGB", and then press SELECT button.13When connect a computer output [5 BNC Type (Red, Green, Blue,Horiz. Sync and Vert. Sync.)] from a computer to R/Pr, G/Y, B/Pb, H/HVand V jacks.WHEN SELECT INPUT 2 (5 BNC INPUT JACKS )Input 2INPUT MENUMove a pointer to RGB andpress SELECT button.INPUT Menu iconMove a pointer (red arrow) toInput 2 and press SELECTbutton.Source Select MenuPress POINT DOWN button to move a red arrow pointer to Input2 and then press SELECT button. Source Select Menu willappear.2