27COMPUTER INPUTMANUAL PC ADJUSTMENTThis projector can automatically tune to display signals from most personal computers currently distributed.However, some computers employ special signal formats which may not be tuned by the Multi-Scan system ofthis projector. If this happens, the projector cannot reproduce proper image and it may be recognized as aflickering; non-synchronized; non-centered; or skewed picture.Manual PC Adjustment of this projector enables you to precisely adjust several parameters to match with thosespecial signal formats. This projector has 10 independent memory areas to store those parameters manuallyadjusted, which allows you to recall setting for a specific computer whenever you use it.Note: The PC ADJUST Menu cannot be operated when the digital signal input on the DVI terminal is selectedon PC SYSTEM Menu. (p.25)Press the MENU button to display the On-Screen Menu.Press the POINT LEFT/RIGHT buttons to move the red framepointer to the PC ADJUST Menu icon.12 Press the POINT UP/DOWN buttons to move the red framepointer to the desired item, and then press the SELECTbutton. An Adjustment dialog box appears. Press the POINTLEFT/RIGHT buttons to adjust the value.Eliminate a flicker from the display. Press the POINT LEFT/RIGHTbuttons to adjust the value. (From 0 to 31.)Fine syncAdjust the number of total dots in one horizontal period. Press thePOINT LEFT/RIGHT buttons to adjust the number to match yourPC image.Total dotsPress the POINT LEFT/RIGHT buttons to adjust the horizontalpicture position.Position HPress the POINT LEFT/RIGHT buttons to adjust the vertical pictureposition.Position VPress the SELECT button to show H-sync freq. and V-sync freq. ofthe connected computer.Current modeAdjusts the clamp level. When the image has a dark bars, try thisadjustment.ClampPress the SELECTbutton at the Currentmode icon to showinformation of thecomputer connected.Current modePC ADJUST MENUAdjusts the horizontal area displayed by this projector. Press thePOINT LEFT/RIGHT buttons to decrease/increase the value.Display area HAdjusts the vertical area displayed by this projector. Press thePOINT LEFT/RIGHT buttons to decrease/increase the value.Display area VPC ADJUST Menu iconMove the red frame pointer to an itemand press the SELECT button.Press the POINT LEFT/RIGHTbuttons to adjust the value.Press the SELECT button at this iconto adjust “Clamp,” “Display area H,” or“Display area V.”Selected ModeShows status (Stored/Free)of the selected Mode.Press the SELECT button at this iconto display the previous items.