Sanyo PLC-XTC50AL Specifications

Also see for PLC-XTC50AL: Owner's manual Specifications Service manual

Contents

PLC-XTC50AL Expand Serial Command Functional Specifications42/768.10.17 CF_SHUTH CommandCommand “CF_SHUTH_%1” [CR]%1“005”-“180”----------Specify setting time directly“UP” ------------------ Add 1 minute“DN” ------------------Decrease 1 minuteDetailsSet time of operating shutter management function.(Valid only when in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.18 CF_PJPINCODE CommandCommand “CF_PJPINCODE_%1” [CR]%1 “0000 – 9999” ------------- Directly specify PJ PIN codeDetailsEnter PIN code to cancel PIN code lock (Available only in the normal Power ONstatus)PIN code can not be changed. (Only PIN code lock is canceled.)*When PIN code Lock is enabled:PIN code is matched ------------------------- Command is valid (Acceptable)PIN code is mismatched -------------------- Command is invalid (Error code “102”)PIN code is beyond %1 available range ----Command is invalid (Error code “?”)When PIN code lock is canceled:PIN code is within %1 range ----------- Command is valid (Acceptable)PIN code is out of %1 range ----------- Command is invalid (Error code is 102)This command is only valid when “PJ PIN code” dialog is displayed to enter PINcode after Power is ON and Countdown is completed.When PIN code lock is set to “On1”, it needs to send this command every time theprojector is turned on.Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]8.10.19 CF_KEYDIS CommandCommand “CF_KEYDIS_%1” [CR]%1“NONE” ---------------------- RC & Projector keys are valid (All are valid)“RCALL” --------------------- All RC keys are invalid“RCPART” ------------------- Specific RC keys are invalid“KEYALL” -------------------- All projector keys are invalid“KEYPART” ----------------- Specific projector keys are invalidDetails Set a ban on the use of RC keys/ projector keys(Available only in the normal Power ON status)Response Acceptable “000” [CR]Unacceptable “Error Code” [CR]