Sanyo PLC-XU300A - 3000 Lumens Manual

Also see for PLC-XU300: Specifications Owner's manual Brochure Specifications Owner's manual

Contents

Sanyo PLC-XU300A - 3000 Lumens Manual Manual pdf 17 page image

PLC-XU300/350 Expand Serial Command Functional Specifications16 / 668.4 Image Command8.4.1 CF_BRIGHT CommandCommand "CF_BRIGHT_%1”[CR]%1"000~063” --------------- Directly select Brightness setting value"UP” ----------------------- Current Brightness setting value + 1"DN” ----------------------- Current Brightness setting value – 1DetailsSet Brightness value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.2 CF_CONT CommandCommand “CF_CONT_ 1”[CR]%1“000~063” --------------- Directly select Contrast setting value“UP” ----------------------- Current Contrast setting value + 1“DN” ----------------------- Current Contrast setting value – 1DetailsSet Contrast value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable "Error Code”[CR]8.4.3 CF_COLOR CommandCommand “CF_COLOR_%1”[CR]%1“000~063” ---------------- Directly select Color setting value“UP” ------------------------ Current Color setting value + 1“DN” ------------------------ Current Color setting value - 1DetailsSet Color value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.4.4 CF_TINT CommandCommand “CF_TINT_%1”[CR]%1“000~063” --------------- Directly select Tint setting value“UP” ----------------------- Current Tint setting value + 1“DN” ----------------------- Current Tint setting value – 1DetailsSet Tint value of user controlThe value set by this command will not be saved to projector. Therefore, whenturning into Stanby-mode or ALL is OFF, the value returns to original setting. (Thevalue is held in Suspend mode.)This command is available in normal Power ON status.Response Acceptable “000”[CR]