Chapter 4 Wired LAN configurationsSetting ProcedureSetting procedures and contents differ depending on the LAN installation location.When installing, consult your system administrator to set up the LAN appropriately.Connect the shielded LAN cable to the LAN connection terminal of the projector.Network environment settingsSet the Wired LAN network through the projector menu. Detailed network settings will be made withbrowser. Refer to “6. Basic setting and operation” (p45-64). First, complete the settings described in thischapter before performing steps in “6. Basic setting and operation.”1. Turn on the projector and select “Network” from the input menu of the projector.2. Select “LAN mode select” in the Network menu, and press Point 8 or SELECT button.3. Select similar LAN environment among Wired1, 2 and 3 with the Point ed buttons. Then the Menuwill disappear, the “Please wait...” message will appear, and switching operation will start. Switchingwill take a while and after completing the operation, the “Ready for use” message will appear, and theprojector’s LINK/ACT Lamp will be on or blink.Connecting to the LAN lineLAN Cable**LAN ConnectionTerminal* When the LAN setting is “Off”, the two lamps will not be on.ACT Lamp (Orange)When the projector isconnected to the 100 Base-TX network, light or blink asfollows;- Light when connecting tothe network.- Blink when sending orreceiving the data.LINK lamp (Green)Light green when theprojector is connected to thenetwork.** Please use a shielded LAN cable .
