10. REGISTERING PROCEDURE AND PRINT FORMAT EO1-1115210. REGISTERING PROCEDURE AND PRINT FORMAT10- 110. REGISTERING PROCEDURE AND PRINT FORMATWARNING!When opening the cash drawer, be careful not to let the drawer hit any person.CAUTION!When taking an issued receipt, be sure to confirm that the cutter operation stops. Failure to do this maycause a paper jam or a printer failure.Before starting sale entries, read through the following instructions:TRAINING MODE is available:If you are a beginner in operating this ECR, ask the store manager for practicing in the TRAINING MODE.During your operations, the following may occur:• Errors ...A tone continuously sounds and an error message appear in the upper row of the Operator Display panel.The keys on the keyboard are locked. In this case, read the Error Message (refer to the ERROR MESSAGETABLE, Section 5.1), and depress the [C] key to cancel the error status. Then remove the cause of the errorand perform the operation again.• Manager Intervention is required ...When Error Message “MANAGER REQUIRED” (standard setting; programmable) is displayed, it means thatthe last key or operation requires a Manager Intervention. Depress the [C] key to cancel the error status, andcall the manager for intervention.When the manager comes to intervene with an appropriate key, you may perform the operation again. If youare informed which keys and operations will require Manager Intervention, you can call the manager in advancebefore the error occurs.• Other errors requiring Manager Intervention ...When an error occurs and you cannot think of the cause or the same error occurs again, call your manager.• Receipt or Journal Paper-End is detected ...When Error Message “PAPER END” (standard setting; programmable) is displayed, the receipt or journal roll isabout to end. In this case, the error cannot be canceled by the [C] key. Replace the paper roll with a new one,referring to the paper installing/removing operations in Chapter 6.• Printer Motor-Lock Condition is detected ...If “PRINTER ERROR” is indicated in the lower row of the display panel (“AMOUNT” portion), the Printer Motoris locked due to paper jam, etc. Turn the Power Switch to OFF, and remove the cause of the motor-lock. Referto Chapters 12 and 13.CONDITION SETTING TO START SALE ENTRIESMode Lock: Insert the “REG” key and set it to the “REG” position.Cashier Sign-ON or Cashier Key to ON status:If the [LOG/RECEIPT] (or [LOG]) key is installed, you must sign-ON or sign-IN. (See Section 7.1.)If Cashier Keys are installed, you must set your cashier key to the ON status. (See Section 7.2.)Now you are ready for sale entries.On the following pages are patterns of entering operations, and receipt or journal print format samples due to theoperations. In the operation sequence patterns, “| |” indicates an input through the numeric keys, “[ ]”indicates a depression of the function key, and “---” indicates other registering and/or finalizing operations.Please note that these are merely sample operations. Especially, the receipt or journal print indications merelyshow the standard print format. The actual print format and contents may vary on your machine in accordancewith the differences in specifications, program selections, etc.
