TEC MA-600-1 series Owner's Manual

Contents

TEC MA-600-1 series Owner's Manual Manual pdf 55 page image

11. REGISTERING PROCEDURE AND PRINT FORMAT EO1-1115511.30 Store Coupon11-247. You can select the rounding process of the fractions of the product (result of % calculation) from ROUND OFF(initial setting), ROUND UP, and ROUND DOWN. (Ask your TOSHIBA TEC representative.)8. If the subtotal amount is zero or negative after the [ST] key, a % entry causes an error.For the department or PLU programmed with taxable or food stampable status, if the subtotal amount isnegative, a % entry causes an error.11.30 Store Coupon[STR CPN] Follow DEPARTMENT ENTRYQUANTITY EXTENSION for DEPTsNOTES:1. The [STR CPN] key operation is possible anytime before depressingthe department key.2. The Store Coupon operation is possible during a sale, however, theoperation resulting in a negative subtotal is not possible. By theprogram option setting, the operation outside a sale and that resulting ina negative subtotal will be possible.3. The amount should be between the high amount limit and the low amount limit which are preprogrammed onthe department. When the [LC OPEN] key is depressed, the high amount limit and the low amount limit forthe department will be extended with two higher digits and one lower digit.4. The Store Coupon operation is not possible for PLUs.5. The Store Coupon operation is not possible for negative departments.6. The Store Coupon operation causes an error when the [RTN MDSE] or [VOID] key is depressed.7. The Quantity Extension operation using an integer is possible. That using a quantity with a decimal point isprohibited.8. The Percent Charge/Discount and the Amount Discount operation are not possible for the Store Couponoperation sequence.11.31 Vendor Coupon- - - ([ST]) |Coupon Amount| [VND CPN] - - -NOTES:1. The declaration key operation is possible anytime before depressing the[VND CPN] key.2. When the amount limit for the [VND CPN] key is preset, the couponamount exceeding the limit cannot be entered in REG mode. As theamount limit is not effective in MGR and - modes, the Vendor Couponoperation for a maximum of 7-digit amount is possible. These settingscannot be cancelled by the [LC OPEN] key.3. The Quantity Extension operation is not possible.4. The vendor coupon operation can be performed both inside a sale and outside a sale. (The “credit balance”option is ignored.) The vendor coupon amount exceeding the subtotal amount can be entered.For the department or PLU programmed with taxable or food stampable status, the amount exceeding eachsubtotal amount can also be entered.When the taxable or food stampable amount is negative, the Vendor Coupon operation is performed on it.OPERATION-- Receipt Print Format --S.CPNDP 01 -0.50OPERATION-- Receipt Print Format --SUBTL $8.00V.CPN -4.00