58 Operating in conventional mode2 Press the low-power transmit function key again toturn low-power transmit off, and the message Lowpower tx deactivated appears on the display.Ending active callsFor analog channels, you may have a function keyprogrammed to either end the current call, or end thecurrent call and all other active calls in your group.This can be done either by:■ using the function key programmed for resetmonitor to end your current call,■ using the function key programmed for call clear-down to end your current call and all other calls inyour group, or■ using the function key programmed for both resetmonitor and call cleardown.Using a function key to end your current call■ Press the function key programmed for resetmonitor. The radio’s monitor is turned off, endingyour current call.The green LED stops flashing, and the monitoricon disappears from the display.Using a function key to end all active calls■ Press the function key programmed for call clear-down and monitor is turned off for all radios inyour radio group.The green LED stops flashing, and the monitoricon disappears from the display.Using the function key programmed for resetmonitor/call cleardown to end active callsThe function key programmed for reset monitor maybe programmed so that a short key press ends yourcurrent call, and a long key press ends all active callsin your group.
