User Manual 5-5PRINTER SETUP USING THE EWSNetworking3. Double-click [Local Area Connection] and click [Properties] in the [Location AreaConnection Status] dialogue box.4. If the [Internet Protocol (TCP/IP)] is not listed, click [Install.].5. In the [Select Network Component Type] dialogue box, select [Protocol] then click [Add].6. In the [Select Network Protocol] dialogue box, select [Internet Protocol (TCP/IP)] thenclick [OK].7. The Windows XP installation CD-ROM may be required. Follow the remaining dialoguebox prompts.Once the protocol has been installed and configured in Windows, the next step is to configurethe TCP/IP parameters in the network printer.CONFIGURING AS A NETWORK PRINTERThe printer CD will auto install the PCL6 driver. Other drivers on the CD can be installedmanually as detailed below.WINDOWS 95/98/MEWhen printing using TCP/IP, use the Microsoft LPR.WINDOWS NT 4.0With Windows NT 4.0, use the Microsoft LPRIn order to use Microsoft LPR, it must first be installed into your operating system.NT 4.0 requires administrator privileges.Microsoft LPRTo install this port, the following needs to be carried out.1. Select [Start], [Settings], [Control Panel] and then select [Printers].2. Select [Add Printer] Wizard.3. Select [My Computer] and then [Next].4. Select [Add Port].5. Select [LPR Port] and then [OK].6. In [Name or address of server providing lpd] type the host name or IP address of the hostfor the printer you are adding.7. In [Name of printer or print queue on that server] type the logical printer name “lp” andthen click [OK].8. Follow the instructions on the screen to finish installing the LPR-compatible printer.If the LPR port is not available, install the Microsoft TCP/IP Printing Service.
