5-10 User ManualPRINTING FROM UNIXNetworkingINTERFACEThe printer LPD is available on the following interfaces:• Ethernet 100BaseTX• Ethernet 10Base-TThe applicable frame types conform to Ethernet II.SET UP PROCEDUREThe setting procedure is as follows:1. Setting up the printerSet the IP address on the printer Operator Panel.Use the printer Operator Panel or the EWS to set the LPD port to [Enable] (default:[Enable]).NOTE: Before activating the LPD port, set the IP address of the printer. For details on how to set the IPaddress and the port, refer Printer Configuration. The EWS allows more detailed settings.2. Settings of the workstationSet the printer in the workstation.Refer to: “SETTING UP THE WORKSTATION” on page 10SETTING UP THE WORKSTATIONThis section explains the settings of Solaris 2.x workstation for printing.Before SetupBefore setting up the workstation, check the following:• The setup procedures and commands may vary according to different versions of OS.• To setup the printer, the user must be a superuser. Contact your networkadministrator to perform the setup if you do not have the authority of a superuser.• Check the IP address set up for the printer in advance. Be cautious as an incorrect IPaddress may cause severe errors.• Before performing any network setup (such as the IP address) to a host running underNIS (Network Information Service), consult the NIS administrator.
