Tascam CD-RW900mkII Owner's Manual

10 TASCAM CD-RW900MKII1 − IntroductionBeware of condensationIf the unit (or a compact disc) is moved from a cold to a warmplace, or used after a sudden temperature change, there is adanger of condensation; vapor in the air could condense on theinternal mechanism, making correct operation impossible. Toprevent this, or if this occurs, let the player sit for one or twohours at the new room temperature before using.• Do not expose the infra-red receiver (light receptivearea on the front panel) to direct sunlight or intense lightfor extended periods of time. Long exposure to this lightmay result in failure of the remote control sensor.• When the remote control will not be used over onemonth, please remove the batteries to prevent the possi-bility of battery acid leakage which could damage theunit. Should leakage occur, remove and discard thebatteries, and wipe the battery case thoroughly with acloth. Avoid getting the battery liquid on the skin. Aftercleaning, replace with new batteries.• The remote control functions by using an infrared lightsignal. When using the unit to control the CD-RW900MKII,other devices that are turned on could be operated by itssignal.• If the range of remote operation becomes smaller, orcommands do not always function properly, the batter-ies have become weak and should be replaced. Alwaysreplace both batteries with new batteries of the same type.• Point the remote control to the remote sensor on themain unit. Do not obstruct the path between the remotecontrol and the remote sensor.Use of the remote control unitConnectionsThe following should be noted when you connect the unit toother equipment.It is possible to connect the unit’s DIGITAL COAXIAL IN,DIGITAL OPTICAL IN and ANALOG UNBALANCED INs (L,R) to other equipment at the same time. However, the unit canreceive signals from only one digital input at a time.Currently selected input jack is shown on the display.Audio signals output from the unit are output from the analogANALOG OUT jacks, as well as from the DIGITAL COAXIALOUT jack and DIGITAL OPTICAL OUT connector simultane-ously (but not from the digital outputs in stop mode).If batteries are used improperly, or if leakage or breakage occurs,the unit will not function.Please observe the cautions indicated on the batteries and theirpackaging to ensure proper usage.• Confirm + and – polarity and follow the indicationswhen inserting new batteries into the remote control.• Do not use old and new batteries together.• Even if the battery is the same size, the voltage may differ.Do not use batteries of different specifications together.• Do not attempt to recharge batteries that are non-rechargeable.• Do not open or disassemble batteries, throw them into afire or put them in water.ª Inserting batteries1. Open the lid.2. Confirm +/- polarity, and insert two AAA batteries.3. Close the lid.Batteries