TASCAM CD-RW901When audio signal is not detected for more than fiveseconds, the CD-RW901 automatically will stop record-ing and enter record standby mode.S_LVLREC readyleveltimeFive secondsNOTEWhen the input level drops below the adjustedthreshold level for more than five seconds, record-ing stops automatically and enters in recordingready mode.3. To cancel the Sync recording mode, press theSYNC REC key. Recording returns to normaland continues till you press the STOP key or thesource signal stops.Pressing the STOP key stops recording.The setting remains when the function is set onagain.NOTEIf you set the value so that only high-level signalstrigger recording, remember that the start of apiece may not be record as in the diagram.Recordsing startsleveltimeThis part of thetrack may not berecordedS_LVLAlso remember that when recording from an ana-log source, the threshold should be set so that it ishigher than the “noise floor”. If the “noise floor” ishigher than the threshold, a false start will occur:S_LVLleveltimeNoise is higherthan thresholdStart of track is not registeredSync recording with trim functionThis Sync trim function allows you to override the auto-matic sync recording where necessary, to chang the starttime of the track forwards or backwards.Use the SYNC TRIM option in the REC sub-menu toturn the function on (see “Operation basics” on page16).The available trim range is from -125 through +125frames.Turn the MULTI JOG dial to adjust the trim value.Automatic track divisionThe trigger level can also be used to divide tracks if theA_TRACK (auto track) function is enabled.When this function is enabled, the unit automaticallyinserts a track division in the recorded material.To enable or disable automatic track division:1. Use A_TRK option in the REC sub-menu to setthe mode on. The A.TRACK indicator at the top rightof the display lights.2. Rotate and push the MULTI JOG dial to selectand enter the modes following:DD (digital direct)When recording digitally from MD, CD or DAT, thismode detects a track boundary and divides the track.However, when the DD mode is on, and if the analogsource or non-DAT/CD/MD digital connections aredetected, the track number will be incremented using•level detection, as set with the A_TRK LEVEL set-ting as described here.When AES/EBU is selected, this mode cannot beused.LevelWhen the sound level has dropped below the thresh-old for more than two seconds, and sound hasre-started, the track will be divided.Use A_TRK LEVEL option in the REC sub-menu.The trigger level is set to -24dB to -72 dB.A_LVLAt least2 secondsleveltimeTrack increment•5 − Recording