24 TASCAM DA-30004 – RecordingMonitoring the input signalInput signal monitoring is usually only on during recording andwhen in recording standby. You can, however, also enable inputmonitoring when the unit is stopped.Follow the procedures below to make this setting.1. Press the MENU button repeatedly to open the I/OSETTINGS menu, and turn the MULTI JOG dial to select INMONITOR.2. Press the MULTI JOG dial to open the INPUT MONITORscreen.3. Turn the MULTI JOG dial to turn input monitoring on or off.Options: OFF (default), ON4. Press the MULTI JOG dial to confirm the selection and returnto the menu screen.NOTE• Monitoring cannot be turned on during playback or whenpaused.• When monitoring is on, playback (including pausingplayback) is not possible.Adjusting the input signal levelYou can use the menu to adjust the level of the input signal.1. Press the MENU button repeatedly to open the I/OSETTINGS menu, and turn the MULTI JOG dial to selectINPUT VOL..2. Press the MULTI JOG dial to open the INPUT VOLUMEscreen.NOTEThe LEVEL item shows the input levels.3. Turn the MULTI JOG dial to adjust the VOLUMEitem, whichis the input signal level.Options: MUTE, −60dB – +12dB (default: 0.0dB)CAUTIONThe level meter OVER indicators will light at the followinglevels. If the DSD mode is set to +3, though, they will light at+3dB and higher.• PCM recording and playback: 16-bit full-scale• DSD recording and playback: 0dB4. Press the MULTI JOG dial to confirm the selection and returnto the menu screen.NOTEThe input signal level setting is retained even when the unitis off.Setting the peak hold indicatorsYou can set how long the peak hold indicators appear on thelevel meters.1. Press the MENU button repeatedly to open the UTILITYmenu, and turn the MULTI JOG dial to select PEAK HOLD.2. Press the MULTI JOG dial to open the PEAK HOLDscreen.3. Turn the MULTI JOG dial to set how long the peak holdindicators appear.Options:“OFF”: No Peak Hold indicators are shown.“2s” (default): Peak Hold indicators are shown for 2seconds.“INF.”: Peak Hold indicators are shown until the EXIT/CANCEL [PEAK CLEAR] button is pushed.4. Press the MULTI JOG dial to confirm the selection and returnto the menu screen.