Tascam DA-302 Owner's Manual

18Section 6 : Playback1 Set the COMMON MODE switch to OFF.2 Press the PLAY key to start playback.… When the REW key (F FWD key) is pressed duringplayback, 2 times (3 times) normal speed rewind cueing(fast-forward cueing) is performed. Pressing it oncemore allows 4 times (6 times) normal speed cueing.Pressing it once more restores 2 times (3 times) cueing.To restore normal playback, press the PLAY key.… Holding the REW key (F FWD key) pressed for 1 sec-ond or more during playback performs 2 times (3 times)normal speed rewind (fast forward) cueing for as long asthe key is pressed. Releasing it restores normal play-back.… Pressing the REW key during fast-forward cueingswitches to 2 times normal speed rewind cueing.… Pressing the F FWD key during rewind cueing switchesto 3 times normal speed fast-forward cueing .… Playback signals are output from the ANALOG OUTand DIGITAL OUT connectors of Deck 1 (Deck 2).6-1. Normal playbackWith continuous playback, the tapes in Deck 1 and Deck2 are played back continuously.1 Set the COMMON MODE switch to "1 > 2".2 Set "Seqtime" in the menu. (úp.28)3 Press the PLAY key on Deck 1 to start playback.When the ABS time of Deck 1 reaches the time setwith "Seqtime", Deck 2 starts playback automatically.4 Deck 1 automatically rewinds the tape to the beginningeither 3 minutes after the time set with "Seqtime" orwhen the tape end is reached.5 Deck 2 automatically rewinds the tape to the beginningeither 3 minutes after the time set with "Seqtime" orwhen the tape end is reached.… The playback signals are output from the ANALOGOUT and DIGITAL OUT connectors of Deck 1(Deck 2).6-2. Continuous playbackWhen a Skip ID is detected during playback, the tape isfast-forwarded to the next Start ID and resumes playback.1 Select the deck with the SELECT 1/2 key.2 Press the MENU key to show the following menu inthe time display.Skip1 Off3 Set to "On" with the UP/DOWN key to engage theSkip Play mode.… If the STANDBY key is set to ON, the Play-Pause modeis engaged at the Start ID.6-3. Skip playbackWhen a Start ID is detected during playback, this functionautomatically engages the Play-Pause mode.1 Select the deck with the SELECT 1/2 key.2 Press the MENU key to show the following message inthe time display.Single1 Off3 Set to On" with the UP/DOWN key to engage theSingle Play mode.6-4. Single playback… The playback sound can also be monitored through theANALOG CASCADE OUTPUT connectors. When"Cas Out" is set to "Auto" in the menu (úp.28), play-back sound output is switched from Deck 1 to Deck 2 atthe time Deck 2 starts playback. In this status, if thePLAY key of Deck 1 is pressed, you can monitor theplayback sound of Deck 1 again.