3 – Automation overview : AUTO CONFIG14 TASCAM DM Automation GuideThe other on-screen buttons, etc. work in the sameway as for other libraries, allowing deletion, protec-tion, etc. of stored entries.DELETE permanently erases the contents of the high-lighted mix file.CAUTIONThere is no undo for this operation.AUTO CONFIGThe grid represented in the AUTO CONFIG display isused for manual override of the automation’s modeswitching. The selected channel is displayed in theupper left of the display. If the displayed channel ispart of a group, this is indicated in the upper right ofthe grid.The changes made in this grid are applied to channeland controls selected by the APPLY TO buttons at theright of the display. Use the rightmost POD encoderto make this selection. Note that it is not necessary topress ENTER to confirm this setting.When a module or control is set to any mode exceptAuto using this display, that module or controlremains in that mode until it is reset back to Auto.The settings made in this display are saved as part ofthe mix data.NOTEImage settings are part of the PAN control setting.MODULE When selected, the changes in this dis-play will only be applied to the specified control onthe selected channel.ALL MODULE When selected, the changes in thisdisplay are applied to a single control across all chan-nels. For example, with ALL MODULE selected,enabling SAFE in the FADER row places all mixer fadersinto Safe mode.ALL CNTRLS When selected, the changes in thisdisplay are applied to all controls on the selectedchannel. This applies the changes to the libraries.ALL When selected, the changes in this display areapplied to all controls on all channels.COPY This soft key copies the configuration of thecurrently-selected channel into a special clipboardwhere it can then be pasted to another channel. Apopup message appears when this operation is car-ried out.PASTE This soft key (only visible when a configu-ration has been copied) pastes the configuration cop-ied using the COPY soft key to the currently-selectedchannel. Note that there is no Undo for this opera-tion.REVERTThe revert function provides a smooth transitionbetween the events being written and existing mixmoves.Naturally, this only applies to continuous controls,such as faders and pans (there is no smooth transitionthat can be made between the on state and the offstate of a switch).See “Revert Time ” on page 16, “Auto RevertChoices ” on page 16, and also “Disabling AutoRevert” on page 19.Figure 8: AUTO CONFIG display