2 – Starting out with the timecode : Setup8 TASCAM DM Automation GuideWrite some Aux send moves13 Write Aux send moves using the touch-sensi-tive faders:• To place the Auxiliary Sends 1 & 2 underfader control, select the AUX 1-2 level encodermode (SHIFT + top key) and then use the FLIPkey to assign the faders to Aux 1-2 level.• Press the WRITE key and start the timecode.• Touch a fader and move it up or down to writea mix move for Auxiliary Send 1 for thatchannel.Release the fader when your mix move is com-plete. When you release the fader, it automati-cally returns to its previous setting.Writing encoder or POD moves14 Write encoder moves (for example pan):• Turn on the Control Sense timeout (if it is notalready on—see “CONTROL SENSE TIMEOUT & Switch Events ” on page 23).• Select the pan encoder mode.• With timecode running, press the WRITE key.• Turn the encoders to write the mix moves.• After the encoder movement has stopped forone second, the control will automaticallyreturn to its setting before being moved if thecontrol sense timeout parameter is set appro-priately (assuming the Control Sense Timeoutis turned on).NOTEYou may want to disable AUTO REVERT or adjust theCONTROL SENSE TIME OUT using the AUTO SETUP screen,when automating POD or encoder controls.Trimming existing mix moves15 This allows you to trim an existing mix move(that is, to adjust the overall level of themove). For example, the move you wrote instep 6 may be good but the move itself needs tobe louder.• With timecode running, press the TRIM key.• At the desired time, touch the fader to betrimmed with your finger and raise it. You willhear the previous moves with the addition ofthe amount of trim you’re adding.• Release the fader when you are finished trim-ming. The fader returns to reading previous,untrimmed mix moves.Finishing up16 Remember to store your mix into your librar-ies (as described in “Store the current settings” on page 7).Happy mixing!