Tascam DM-3200 Manual

Also see for DM-3200: Quick reference Owner's manual Software guide Application guide Release notes

Contents

4 – Operation : Trimming Mix Moves28 TASCAM DM Automation GuideAuto Revert Choices:With AUTO REVERT — TRIM enabled, the automationsystem stops trimming mix moves automatically percontrol without the need to stop trimming manually.In this case, controls stop trimming mix moves at dif-ferent times, depending on when they were released(faders) or when movement ended (POD controls), orwhen the timecode was stopped.In the case of the touch-sensitive faders, the revertstarts when the fader is released. In the case of PODcontrols and encoders, revert starts when the CONTROLSENSE TIME OUT has expired without movement of thecontrol. CONTROL SENSE TIME OUT allows the POD con-trols to respond as if they are touch-sensitive eventhough they are not.When a Revert occurs, the control smoothly matchesback to its previous data based on the amount ofRevert Time set. That previous data could be a con-trol’s Static position or a control’s Dynamic mixmoves. See the diagrams below to understand howthis works:Figure 24: Trimming fader moves with Auto Revert enabled8 sec8 sec+12+6+30-3-6-12+12+6+30-3-6-121 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec-9Existing Fader MoveMix MoveRaise Fader Release Fader or Stop TimecodeRevertTimeHold FaderFigure 25: Trimming POD and encoder moves with Auto Revert enabled8 sec8 secControlSenseTimeout+12+6+30-3-6-12+12+6+30-3-6-121 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec-9Existing POD MoveMix MoveMove POD Release POD Time out or Stop TimecodeRevertTimePOD Movement