4 – Operation : Writing Mix MovesTASCAM DM Automation Guide 21Write To End:When the Write Revert Time is set to ∞s, you areessentially telling the automation system to maintaina control’s last setting from the point where the auto-mation recording ends, all the way to the end of theprogram. This is called Write To End. In this case,any mix moves existing in the time between the endof automation recording and the end of the programwill be erased.NOTEA Write/Trim to End operation must be completed bystopping the timecode. Manually disabling Write orTrim mode while timecode is running will not perform aWrite To End operation.AUTO REVERT must be enabled to use Write To End.See the diagrams below to understand how thisworks:Figure 17: Write to End over previous Static fader position8 sec8 sec+12+6+30-3-6-12+12+6+30-3-6-121 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec-9Existing Static Fader PositionMix MoveTouch Fader Release Fader Stop Time CodeFaderMovementFigure 18: Write to End over previous Dynamic fader moves8 sec8 sec+12+6+30-3-6-12+12+6+30-3-6-121 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec-9Existing Fader MoveMix MoveTouch Fader Release Fader Stop Time CodeFaderMovement