Tascam US-366 Owner's Manual

Also see for US-322: Quick start guide Quick start guide

Tascam US-366 Owner's Manual Manual pdf 18 page image

18 TASCAM US-322/3665 – Using the US-322/366 Mixer PanelCAUTIONWith the US-366 model, if the sampling frequency is set to176.4 kHz or 192 kHz, the signal selected using the “DIGITALOUTPUTS” item will be output regardless of the “LINEOUTPUTS 3-4” setting.Foot Switch Mode (US-366 only)When using a US-366 with a DAW application, you canconnect a TASCAM RC-3F foot switch remote control (soldseparately) to control the DAW.You can select from two types of functions for the pedals(switches).• PLAY (REW, PLAY/STOP, FWD) (default setting)These assigned functions are particularly useful forplayback operations. The PLAY/STOP function assignedto the center pedal allows you to press it briefly to PLAYand press and hold it to STOP.• RECORD (PLAY, REC, STOP)The assigned functions are useful particularly forrecording operations.FOOT SWL (brief) C (brief) R (brief)L (long) C (long) R (long)PLAY REW PLAY FWD----- STOP -----RECORD PLAY REC STOP----- ----- -----Foot Switch Protocol (US-366 only)You should set the protocol to match the DAW applicationyou are using. If the foot switch remote control does notfunction, change the setting.Mackie: Mackie control protocolHUI: HUI protocolFor information about these protocols and how to use themwith a DAW application, refer to that application's operationmanual.“MIXER” pageClick the MIXER tab to open the page shown above. On thispage, you can adjust the built-in mixer settings.1 DYNAMICS EFFECTS type selectionSelect the type of dynamics effect to use.You can select and use one type of effect at a time. (Simulta-neous selection of two or more effects is not possible.)ON: Effect name blueOFF (default): Effect name grayClick the name of the effect that you want to use to turn iton. When on, the effect name appears blue.Click the name of the effect that is on (name blue) to turn itoff. When off, the effect name appears gray.To use a different effect, click the name of that effect to turnit on. The previously used effect is automatically turned off.This setting is retained even when the unit is turned off andon again.NOTEDepending on the sampling frequency setting, it might notbe possible to turn an effect on.2 Dynamics effect assignmentSelect the channel that you want to use the dynamics effecton.You can select one mono or one stereo channel. (Simulta-neous selection of multiple channels is not possible.)ON: Channel name blueOFF (default): Channel name grayClick the name of a channel to assign the dynamics effect toit. When assigned, the channel name becomes blue.At the same time, the line between the dynamics effects areaand the channel name turns blue.To stop applying the dynamics effect to the assignedchannel, click that channel's button. The line between thedynamics effect area and the channel turns gray.To reassign the dynamics effect to a different channel,click the button of that channel. The dynamics effect willautomatically be removed from the previous channel (lineturns gray) and assigned to the new channel (line turnsblue).This setting is retained even when the unit is turned off andon again.