Tascam US-366 Owner's Manual

Also see for US-322: Quick start guide Quick start guide

Tascam US-366 Owner's Manual Manual pdf 21 page image

TASCAM US-322/366 215 – Using the US-322/366 Mixer Panel“EFFECTS” pageClick the “EFFECTS” tab to open the effects page where you canadjust the built-in effect settings.Limitations on the use of the built-in effectsThe number of built-in effects that can be used depends on thesampling frequency.• At 44.1/48kHz, one dynamics and one send effect can eachbe used.• At 88.2/96kHz, either one dynamics effect or one send effectcan be used. (Turning on an effect will automatically turn offthe other effect if it has been on.)• At 176.4/192kHz, the built-in effects cannot be used.1 Dynamics effect tabsUse to select the dynamics effect that is shown. Click a tabto bring that effect to the front. The dynamics effects are“COMPRESSOR” (default), “NOISE SUPPRESSOR”, “DE-ESSER”,“EXCITER” and “EQ”.This setting is retained even when the unit is turned off andon again.2 Parameter knobsUse these to adjust the effect parameters.Click and drag a knob up or down to adjust its setting value.Drag up to increase the value and turn the knob clockwise.Drag down to decrease the value and turn the knob counter-clockwise.The current value of each parameter is shown above itsknob.For details about each parameter, see “Effect explanations”on page 22.These settings are retained even when the unit is turned offand on again.3 Dynamics effect ON/OFF button and indicatorUse this button to turn a dynamics effect on and off.ON: The button turns red and “ON” appearsnext to it. The name of the effect appearsbrighter.OFF (default): The button dims and “OFF” appears nextto it. The name of the effect appearsdimmed.When a dynamics effect is off, click its ON/OFF button orname to turn it on. When on, click the button or name toturn it off.Moreover since only one dynamics effect can be used at atime, when an effect is on, turning on another effect willautomatically turn that effect off.This setting is retained even when the unit is turned off andon again.NOTE• The dynamics effect ON/OFF setting on this page is linked toits setting on the mixer panel, so turning it on or off here willalso change its setting there.• Depending on the sampling frequency setting, it might notbe possible to turn an effect on.4 Effect type selection switchYou can select the type of reverb used for the send effect.Click the name of the type that you want to use to changethe selection. The switch will point to the new selection, andthe name of the selected type will appear green. The othertypes will appear white. (The default setting is HALL.)For details about each parameter, see “Effect explanations”on page 22.This setting is retained even when the unit is turned off andon again.5 Send effect ON/OFF button and indicatorUse this button to turn the send effect on and off.ON: The button turns red and “ON” appearsnext to it.OFF (default): The button dims and “OFF” appears nextto it.When a send effect is off, click its ON/OFF button or name toturn it on. When on, click the button or name to turn it off.This setting is retained even when the unit is turned off andon again.NOTE• The send effect ON/OFF setting on this page is linked to itssetting on the mixer panel, so turning it on or off here willalso change its setting there.• Depending on the sampling frequency setting, it might notbe possible to turn an effect on.