Terex Genie Z-62 Service And Repair Manual

June 2022 Service and Repair ManualPlatform ControlsPart No. 1268555GT Z ®-62/40 2510 Compare the function ramp rate time with thetable below and determine whether the ramprate time needs to increase or decrease.11 While the joystick is activated, set the ramprate. Momentarily move the drive enabletoggle switch in the right direction to increasethe time or momentarily move the driveenable toggle switch in the left direction todecrease the time.Note: Each time the drive enable toggle switch ismomentarily moved, the time will change in 5%increments.12 Repeat steps 9 through 11 for each joystickcontrolled machine function.13 Return the joystick to the neutral position andwait for approximately 10 seconds to allow thesettings to be saved.Result: The alarm should sound indicatingthat the settings have been saved in memory.Note: Do not operate any machine function duringthe 10 second waiting time.Ramp rate (factory settings)Primary boom up/downaccelerate 3 secondsdecelerate 1 secondSecondary boom up/downaccelerate 2 secondsdecelerate 1 secondTurntable rotateaccelerate 2 secondsdecelerate 0.5 secondDriveaccelerate 2 secondsdecelerate to neutral 0.5 seconddecelerate, change of direction 0.5 seconddecelerate, coasting 0.75 seconddecelerate, braking 1.5 secondsdecelerate, shift from low to highspeed1.75 secondsdecelerate, shift from high to lowspeed - 2WD models1 seconddecelerate, shift from high to lowspeed - 4WD models3.5 seconds