Ubee DDW365 User Manual

Also see for DDW365: User guide

Contents

Ubee DDW365 User Manual Manual pdf 10 page image

Ubee Interactive Understanding the Device Panels, Connections and LEDsUbee DDW365 Advanced Wireless Gateway Subscriber User Guide • February 2014 61.5.2 Understanding the Device ConnectionsThe following table describes the connections on the device.1.5.3 Understanding LED BehaviorThe following tables summarize the behavior of the LEDs on both the front and rearpanels of the DDW365.Item DescriptionUSB Connects to USB devices such as flash drives, hard disk drives,and printers.ETH1ETH2ETH3ETH4Connects to Ethernet devices such as computers, gaming consoles,and/or routers/hubs using an RJ45 cable. Each ETH port on theback panel of the device has an LED to indicate its status when anEthernet device is connected.RESET Restores the settings of the device including wireless and customgateway settings. Use a pointed object to push down the resetbutton for less than 5 seconds to just reset the device. To factoryreset the device, push down the reset button for more than 5seconds.CABLE Connects to the cable outlet (with the cable provided by yourservice provider), or a cable splitter connected to the cable outlet.POWER Connects the cable to the device. Use only the power cableprovided with the DDW365.WPS Located on top of the cable modem, this button is used for the WiFiProtected Setup (WPS) method to connect a PIN-protected WiFidevice to the cable modem. Refer to Understanding the WirelessMenu on page 74 for more information.FRONT PANELLED Color DescriptionPOWER White On – Internal power-on completed successfully.Flashes – Power-on failed. Note that the LED blinks briefly immediately after powering on thedevice.US/DS(upstream/downstream)White Flashes – Once every second while scanning DS. Once locked on DS, flashes twice everysecond while registering the US.On – Locked to US and DS channels and registered OK.Flashes – When a firmware upgrade is in progress, and POWER LED and ONLINE LEDs areON solid.