9Chapter 2: InstallationairFiber A F-11FX U ser G u ideUbiquiti Networks, Inc.a. For the Management IP Address option:‑ DHCP Keep the default, DHCP, to use DHCPreservation on your router to assign a uniqueIP Address.‑ Static Change the IP Address, Netmask, and othersettings to make them compatible with yournetwork.b. Click Save Changes.11. Disconnect the Ethernet cables from the MGMT andDATA ports on the AF‑11FX. Configuration of theAF‑11FX radio is complete.Repeat the instructions in the airFiber Configurationsection on the other AF‑11FX radio.Hardware InstallationInstall a Ground Wire1. Remove the nut from the Ground Bonding Point locatedon the back of the AF‑11FX, near the lower‑right corner.GroundBondingPoint2. Attach a ground wire (min. 10 AWG or 5 mm2) to thelug and replace the nut to secure the wire.3. At the installation site, secure the other end of theground wire to a grounded mast, pole, tower, orgrounding bar.WARNING: Failure to properly ground yourairFiber X radio will void your warranty.Note: The ground wire should be as short aspossible and no longer than one meter in length.Mount to the airFiber X AntennaFollow the instructions in this section to mount theAF‑11FX radio to an airFiber X AF‑11G35 antenna:1. Attach an RF Cable to an RF connector labeled H or V.Then slide the silicone boot over the RF connector toprotect it.Note: For SISO mode, use the RF connector(H or V) as determined by your licensing. Keepthe other RF connector covered with theincluded Metal Cap.If using MIMO mode, remove the cap over the secondRF connector (V or H) and attach an RF Cable. Then slidethe silicone boot over the RF connector to protect it.H Connector V Connector2. Attach the AF‑11FX radio to the antenna by aligningthe four tabs on the back of the radio with the slots ofthe radio mount. Then slide the radio down to lock itinto place.