100Template Go, Version 1, 01.07.2014 / ModuleVersion 1.0ECO DECTECO DECTThe device range is set to maximum as default. This guarantees the best connection betweenthe handset and the base station. In idle status, the handset will not function (as it is nottransmitting). Only the base station will maintain contact with the handset via a low wirelesssignal. During a call, the transmission power automatically adapts to the distance between thebase station and handset. The smaller the distance to the base, the lower the radiation.To reduce the radiation further:Reducing radiation by up to 80%¤ . . . use to select Settings OK ECO DECT OK MaximumRange Change ( = off )Deactivating radiation in idle status¤ . . . use to select Settings OK ECO DECT OK NoRadiation Change ( = on)The range is also reduced with this setting.It is not possible to use a repeater to increase the range.To benefit from the advantages of the setting No Radiation, all registered handsetsmust support this feature.If the setting No Radiation is activated and a handset is registered to the base thatdoes not support this feature, No Radiation is automatically deactivated. As soon asthis handset is de-registered, No Radiation will automatically be re-activated.The wireless connection will only be established for an incoming or outgoing call andthe connection will be delayed by about 2 seconds.In order that a handset can establish a wireless connection with the base station morequickly for an incoming call, it must "listen" to the base station more often, i.e. scanthe environment. This increases power consumption and reduces the standby andtalktime of the handset.When No Radiation is activated, there will be no range display/range alarm on thehandset. Contactability can be tested by attempting to establish a connection.¤ Press and hold the Talk key . . . the ringing tone will sound.