143CTI callsBeep on auto-answerWhen you dial a number with a CTI application (e.g. Outlook) and auto-answeris activated, the phone switches automatically to speakerphone mode. If auto-answer is deactivated, the phone first rings and you have to press the loud-speaker key or lift the handset in order to set up the call. This setting also defineswhether or not incoming calls are automatically accepted. If the function is ac-tive, an alert beep sounds when a call is automatically accepted.Information on the operation of the configured CTI application can be found inthe corresponding operating instructions.z You can also configure this setting via the web interface page 172.@ Press the key shown if appropriate.Open using the Softkey.Open using the Softkey.if nec. j Enter and confirm the User password.Open using the Softkey.Open using the Softkey.Open using the Softkey.Enable or disable using the Softkey.and€ Switch to AutoAnswer beep.Enable or disable using the Softkey.Save the setting with the Softkey.Beep on auto-reconnectYou can reconnect a held call both via the CTI application and via the phone. Abeep sounds when you toggle between an active call and a held call when thefunction is active.z You can also configure this setting via the web interface page 172.ñ The option was programmed by your administrator.Settings _$ User settings - _$ Configuration - _$ Incoming calls - _CTI calls - _AutoAnswer ¢ _AutoAnswer beep ¢ _Q _
