Video function 183Holding a callYou place the call on hold for example to consult with someone else in the room.Select the softkey to confirm. The video display is interrupted.The video image of your call partner appears again when you reconnect.Installing a USB cameraYou will find USB cameras at the following link, which are recommended for useon the OpenScape Desk Phone IP 55G. While the link refers to OpenStagephones it is likewise valid for OpenScape Desk Phone IP 55G:http://wiki.unify.com/wiki/Video_Telephony_for_OpenStage_SIP_60/80.Do not connect any USB cameras that are not supported as this can cause thephone to malfunction.Connecting a USB cameraPlug the USB connector of the camera into the USB port on the bottom of yourOpenScape Desk Phone IP 55G (see Page 17).If you see the following message, the USB camera has been detected and canbe used.Activating and deactivating the video functionz You can also configure this setting via the WBM interface Page 247.Press the key shown until the "Settings" tab is active.Confirm the option shown.if nec. j Enter and confirm the user password.Select and confirm the option shown.Select and confirm the option shown.Select the option shown.Select and confirm the option shown in the context menu to activate the function.The video function is disabled by default.orSelect and confirm the option shown in the context menu to deactivate.Select the softkey to confirm.HoldNew USB device detectedvideo.camera USB2.0 CameraServicesUserConfigurationVideo CallVideo onYesNoSave & Exit
