- 84 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS282 User’s Manual3.8 Discrete 2 of 5 (DTF)Scan one of the following bar codes to enable or disable Discrete 2 of 5.3.8.1 Set Lengths for Discrete 2 of 5The length of a code refers to the number of characters (i.e., humanreadable characters), including check digit(s) the code contains. Setlengths for D 2 of 5 to any length, one or two discrete lengths, or lengthswithin a specific range. The default is One Discrete Length: 12.Note: When setting lengths, enter a leading zero for single digit numbers.Scan one of the following bar codes to select a length option:• One Discrete Length - Decode only D 2 of 5 symbols containing aselected length. Select the length using the barcodes in Appendix B, Numeric Bar Codes. Forexample, to decode only D 2 of 5 symbols with 14characters, scan D 2 of 5 - One Discrete Length,and then scan 1, 4. To correct an error or changethe selection, scan Cancel.• Two Discrete Lengths - Decode only D 2 of 5 symbols containing either oftwo lengths. Select lengths using the bar codesin Appendix B, Numeric Bar Codes. For example,to decode only D 2 of 5 symbols containing either2 or 14 characters, scan D 2 of 5 - Two DiscreteLengths, and then scan 0, 2, 1, 4. To correct anerror or change the selection, scan Cancel.Enable Discrete 2 of 5Disable Discrete 2 of 5*
